Along the northern piedmont of Mt. Lishan, the characteristics and locations of the active normal Lishan fault in west of Huaqing Pool provide important evidences for determining the seismotectonic environment, seismic stability evaluation of engineering in the eastern Weihe Basin. After reviewing the results from high-density resistivity method, seismic profile data, geological drillhole section and trenching in west of the Huaqing Pool, it is found that the strike of western normal Lishan Fault changes from EW direction at the eastern part to the direction of N60°W, and the fault consists of two branches, dipping NE with a high dip angle of~75°. The artificial shallow seismic profile data reveals that the attitude of strata near Lishan Fault mainly dips to south, which is presumed to be related to the southward tilt movement of Mt. Lishan since the Cenozoic. The section of geological drillhole reveals that since the late middle Pleistocene, the displacement of the paleo-soil layer S₂ is about 10m. And the maximum displacement of western Lishan Fault recorded in the paleo-soil layer S₁ reaches 7.8m since the late Pleistocene.
In addition, evidences from trench profile show that the western Lishan Fault was active at least 3 times since Malan loess deposition with ¹⁴ C dating age(32 170±530)Cal a BP. The multiple activities of the Lishan Fault result in a total displacement about 3.0m in the Malan loess layer L₁. The latest activity of the western Lishan Fault produced a displacement of about 0.9m in the early Holocene loess layer L₀((8 630±20)Cal a BP)and caused obvious tensile cracks in the Holocene dark leoss layer S₀((4 390±20)Cal a BP). Briefly, we have obtained a vertical movement rate of about 0.11~0.19mm/a since the Holocene((8 630±20)Cal a BP)in the western extension of the Lishan Fault, the recurrence interval of earthquakes on the fault is about(10.7±0.5)ka, and the co-seismic surface rupture in a single event is inferred to be about 0.9m.

The southern segment of the Xiaojiang Fault (SSXF) is located at the intersection of the Xianshuihe-Xiaojiang Fault and Red River-Ailao Shan fault systems in the southeast margin of the Tibetan plateau. Based on the interpretation of remote sensing image, the SSXF clearly shows the linear feature and continuous distribution as a single, penetrating fault. It has a total length of about 70km, trends generally about 20° to the northeast and protrudes slightly in the middle to the east. A typically geomorphologic phenomenon about the synchronous left-lateral dislocation of ridges and gullies can be found at Liangchahe, Longtan Village along the SSXF. The distribution of faults, the sedimentary features, attitude variance and the primary dating results of the offset strata in the trench section across fault sag ponds reveal three paleoseismic events rupturing obviously the surface, which demonstrates that the SSXF has the ability of recurrence of strong earthquakes. High-precision topographic map about two gullies and the platform between them with synchronous dislocation is acquired by using the Trimble 5800 GPS real-time difference measurement system. The dislocation is (18.3±0.5)m. As the top geomorphologic surface between the above two gullies and their adjacent area, the terrace surface T₂ stopped accepting deposits at ~2606a, based on the linear regression analysis of three dating data. According to the geological method, a sinistral strike-slip rate of (7.02±0.20)mm/a on the SSXF in the Holocene is obtained, which has a good consistency with the results provided by using GPS data. The preliminary results about the Holocene activity and slip rate of the SSXF demonstrate that the southward or south-southeast motion of the Sichuan-Yunnan block in the SE Yunnan region has not been absorbed by the possible shortening deformation and the sinistral strike-slip rate of the SSXF has not been drastically reduced. The SSXF is a Holocene fault with obvious activity. This preliminary understanding provides some basic geological data for the seismic risk evaluation of the SSXF in the future, and for the establishment and inspection of the seismotectonic model about the Sichuan-Yunnan block.

The accurate relocations of small earthquakes during 1990-2011 on the arcuate tectonic belt in southeast Yunnan (23°N to 25°N,101°E to 103°E) are obtained by hypo2000 and double difference algorithm using Pg and Sg phase readings of 721 earthquakes recorded by Yunnan Earthquake Network Center.The RMS residual decreases to 0.45 from 1.43 with an average precision of about 1.4km horizontally and 1.9km vertically after relocation. Then we collected the waveform data of the study region during 2007-2012 and calculated the focal mechanisms of 148 small earthquakes with the method of the maximum amplitude ratio between Pg and Sg. Focal mechanism result shows that the number of nodal planes representing normal strike-slip is almost twice of that of the reverse strike-slip,which demonstrates that the dominant movement on the arcuate tectonic belt is normal strike-slip currently. Relocation of small earthquakes greatly improves the definition of the seismic images on the faults that generate them. According to the relocated focal depths,the Qujing Fault and Shiping-Jianshui Fault dip southwest,and the Honghe Fault dips northeast,which are in accord with the fault geometric characteristics revealed by crustal velocity profiles. According to this,the rollback of Sumatra-Myanmar trench has already brought a deep effect on the arcuate tectonics in southeast Yunnan,the compression caused by the slip of Sichuan-Yunnan rhombic block towards SSE may be weakened. So the tensile stress in SWW-NEE direction plays a more important role in present-day activities of the arcuate tectonics compared to the compressive stress in SSE-NNW direction,which can also be deduced from the characteristics of focal mechanism parameters. A transtensional zone may be emerging from the arcuate tectonics in southeast Yunnan.