Journals
  Publication Years
  Keywords
Search within results Open Search
Please wait a minute...
For Selected: Toggle Thumbnails
LATE QUATERNARY ACTIVITY CHARACTERISTICS OF THE TANGBAL-TASDUN FAULT ZONE IN THE EASTERN TIENSHAN AREA
HUANG Shuai-tang, HU Wei-hua, YANG Pan-xin, LI Shuai, Yiliyaer
SEISMOLOGY AND GEOLOGY    2020, 42 (5): 1058-1071.   DOI: 10.3969/j.issn.0253-4967.2020.05.003
Abstract844)   HTML    PDF(pc) (10114KB)(208)       Save
There were several strong earthquakes of MS≥7.0 occurring in the eastern Tianshan in the history, which is an important part of Tianshan earthquake zone. The Tangbal-Tasdun Fault is a left-lateral strike-slip fault zone of Late Pleistocene in the northwest of Barkol Basin. The study of the characteristics of its late Quaternary activities is one of the important basic work to understand the risk of strong earthquakes in Barkol area. Due to the low level of research in the eastern Tianshan region, there is a lot of controversy over the historical earthquakes. But there is no doubt that this area has the ability of generating earthquakes of magnitude greater than 7.0. Current GPS monitoring data on both sides and inside of Tianshan Mountains shows an about 20mm/a northward movement of the Pamir and Tarim plates, but a 4mm/a crustal movement rate of eastern Tianshan. This indicates that the tectonic activity of the western section of Tianshan Mountains is obviously stronger than that of the eastern section. However, according to the historical earthquake records of eastern Tianshan, there are at least two earthquakes of magnitude 7 or above happening in Barkol region. This indicates that the tectonic activity in the Barcol area is intense and the area has the condition for generating strong earthquakes.
In this paper, the methods of high resolution satellite image interpretation, field observation and analysis, micro-geographic survey and trenching are used. The geometric distribution characteristics of the Tangbal-Tasdun Fault are determined, which reveals the movement and activity of the fault zone. The activity parameters of the fault since late Pleistocene are preliminarily obtained. The results show that the fault is left-handed strike-slip with thrust motion. A surface rupture zone with a length of about 50km is developed in the east of Jijitaizi Village. The fault offset the T2 terrace with a vertical displacement of about 0.9m and a horizontal displacement between 9m and 11m. The vertical displacement of T3 terrace is about 1.6m, and the horizontal displacement is between 13m and 20m. To the west of Hongjingzi Town and Tashbastawu Village, the fault is distributed in a straight line on satellite images. The fault offset the latest geomorphic surface, with the minimum vertical displacement of about 0.1m, the maximum vertical displacement of 2m, and the horizontal displacement of 1.8~4.3m. The horizontal displacement of the fault is larger than the vertical displacement of the same period. The excavation of a trench near Kutaizi village shows that the fault has obvious characteristics of strike-slip movement. According to the phenomena of water spraying and sand emitting along the fault and the relation of cut and cover between the fault and strata, two ancient seismic events are revealed in the trench. The most recent event ruptured the ground surface. According to the empirical formula for magnitude estimation, M=7.13+0.68lgD, it is calculated and inferred that this fault section is qualified for the occurrence of M7.3~7.4 earthquake.
Reference | Related Articles | Metrics
TERRACE DEFORMATION AND SLIP RATES OF THE DONGBIELIEKE FAULT IN WESTERN JUNGGAR BASIN SINCE THE LATE QUATERNARY
YAO Yuan, LI Shuai, HUANG Shuai-tang, JIA Hai-liang
SEISMOLOGY AND GEOLOGY    2019, 41 (4): 803-820.   DOI: 10.3969/j.issn.0253-4967.2019.04.001
Abstract635)   HTML    PDF(pc) (10048KB)(368)       Save
Strike-slip fault plays an important role in the process of tectonic deformation since Cenozoic in Asia. The role of strike-slip fault in the process of mountain building and continental deformation has always been an important issue of universal concern to the earth science community. Junggar Basin is located in the hinterland of Central Asia, bordering on the north the Altay region and the Baikal rift system, which are prone to devastating earthquakes, the Tianshan orogenic belt and the Tibet Plateau on the south, and the rigid blocks, such as Erdos, the South China, the North China Plain and Amur, on the east. Affected by the effect of the Indian-Eurasian collision on the south of the basin and at the same time, driven by the southward push of the Mongolian-Siberian plate, the active structures in the periphery of the basin show a relatively strong activity. The main deformation patterns are represented by the large-scale NNW-trending right-lateral strike-slip faults dominated by right-lateral shearing, the NNE-trending left-lateral strike-slip faults dominated by left-lateral shearing, and the thrust-nappe structure systems distributed in piedmont of Tianshan in the south of the basin. There are three near-parallel-distributed left-lateral strike-slip faults in the west edge of the basin, from the east to the west, they are:the Daerbute Fault, the Toli Fault and the Dongbielieke Fault. This paper focuses on the Dongbielieke Fault in the western Junggar region. The Dongbielieke Fault is a Holocene active fault, located at the key position of the western Junggar orogenic belt. The total length of the fault is 120km, striking NE. Since the late Quaternary, the continuous activity of the Dongbielieke Fault has caused obvious left-lateral displacement at all geomorphologic units along the fault, and a linear continuous straight steep scarp was formed on the eastern side of the Tacheng Basin. According to the strike and the movement of fault, the fault can be divided into three segments, namely, the north, middle and south segment.
In order to obtain a more accurate magnitude of the left-lateral strike-slip displacement and the accumulative left-lateral strike-slip displacement of different geomorphic surfaces, we chose the Ahebiedou River in the southern segment and used the UAV to take three-dimensional photographs to obtain the digital elevation model(the accuracy is 10cm). And on this basis, the amount of left-lateral strike-slip displacement of various geological masses and geomorphic surfaces(lines)since their formation is obtained. The maximum left-lateral displacement of the terrace T5 is(30.7±2.1)m and the minimum left-lateral displacement is(20.1±1.3)m; the left-lateral displacement of the terrace T4 is(12±0.9)m, and the left-lateral displacement of the terrace T2 is(8.7±0.6)m. OSL dating samples from the surface of different level terraces(T5, T4, T2 and T1)are collected, processed and measured, and the ages of the terraces of various levels are obtained. By measuring the amount of left-lateral displacements since the Late Quaternary of the Dongbielieke Fault and combining the dating results of the various geomorphic surfaces, the displacements and slip rates of the fault on each level of the terraces since the formation of the T5 terrace are calculated. Using the maximum displacement of(30.7±2.1)m of the T5 terrace and the age of the geomorphic surface on the west bank of the river, we obtained the slip rate of(0.7±0.11)mm/a; similarly, using the minimum displacement of(20.1±1.3)m and the age of the geomorphic surface of the east bank, we obtained the slip rate of(0.46±0.07)mm/a. T5 terrace is developed on both banks of the river and on both walls of the fault. After the terraces are offset by faulting, the terraces on foot wall in the left bank of the river are far away from the river, and the erosion basically stops. After that, the river mainly cuts the terraces on the east bank. Therefore, the west bank retains a more accurate displacement of the geomorphic surface(Gold et al., 2009), so the left-lateral slip rate of the T5 terrace is taken as(0.7±0.11)mm/a. The left-lateral slip rate calculated for T4 and T2 terraces is similar, with an average value of(0.91±0.18)mm/a. In the evolution process of river terraces, the lateral erosion of high-level terrace is much larger than that of low-level terrace, so the slip rate of T4 and T2 terraces is closer to the true value. The left-lateral slip rate of the Dongbielieke Fault since the late Quaternary is(0.91±0.18)m/a. Compared with the GPS slip rate in the western Junggar area, it is considered that the NE-trending strike-slip motion in this area is dominated by the Dongbielieke Fault, which absorbs a large amount of residual deformation while maintaining a relatively high left-lateral slip rate.
Reference | Related Articles | Metrics
LATE QUATERNARY CRUSTAL SHORTENING RATE OF THE BEILUNTAI FAULT IN SOUTHERN TIAN SHAN, XINJIANG
YAO Yuan, SONG He-ping, CHEN Jian-bo, LI Shuai, JIA Hai-liang
SEISMOLOGY AND GEOLOGY    2018, 40 (1): 71-86.   DOI: 10.3969/j.issn.0253-4967.2018.01.006
Abstract1057)   HTML    PDF(pc) (7565KB)(248)       Save
The Beiluntai Fault is a Holocene active fault. It is the boundary between southern Tian Shan and Tarim Basin. Since the late Quaternary, steady activities of the Beiluntai fault have resulted in offsets, folds, and uplift of pluvial terraces. We used the high-resolution RTK topographic surveys to reveal that the fault scarp morphology on the Akeaiken(Ak) segment and Zhuanchang(Zc) segment of the Beiluntai fault. We found that the crustal shortening of Ak and Zc segments are dominated by thrusting and folding-uplift, respectively. We employed th optically stimulated luminescence(OSL) dating method to develop a new chronology for the different pluvial terraces, indicating that they formed at 49.14~58.51, 27±3, 13.72~14.64, 7.13±0.88, (3.32±0.43) ka, respectively. These data permitted to estimate the crustal shortening rate(about 2.4mm/a) remains largely constant on the Ak segment, while the crustal shortening rate of Zc segment was 1.43~1.81mm/a since the Fan4 pluvial terraces was abandoned. Compared with the Ak segment, the crustal shortening rate of the Zc segment declined obviously. This shows that the NS-trending crustal shortening rate of the Beituntai fault decreased gradually from west to east. A comprehensive comparison of the reverse fault-fold belt system in the front of southern Tian Shan also indicates that the crustal shortening rate drops from west to east.
Reference | Related Articles | Metrics