Strong earthquakes(magnitude>6.5)typically cause coseismic surface ruptures of several kilometers or even hundreds of kilometers long on the surface. Coseismic surface rupture is the most intuitive geomorphic representation of an earthquake on the surface, and its geometry and distribution characteristics provide important information about the fault activity. Field investigation is the most basic means for research on coseismic surface fractures, but for areas that are hard to access or have harsh climatic environments, field investigation is often greatly limited. In recent years, the increasing abundance of high-resolution remote sensing images and the rapid development of photogrammetry methods can help us quickly obtain high-resolution topographic and geomorphic data of the study area, to better identify the fine geometry of the earthquake surface rupture zone and measure the offsets of geomorphic markers along the fault. The Litang Fault is a sinistral strike-slip fault located within the Sichuan-Yunnan rhombic block on the eastern edge of the Qinghai-Tibetan plateau. Several historical earthquake events have occurred on this fault, such as the 1890 and 1948 earthquakes, and clear seismic surface ruptures still exist along the fault so far. Previous studies have conducted a series of works on the coseismic surface rupture of this fault, but most of these works were based on field investigations or relatively low-resolution remote sensing images, and there is still a lack of fine research on the coseismic surface rupture of the fault. In this paper, the coseismic surface rupture of the 1890 earthquake which occurred on the Litang Fault was selected as the study object. To obtain high-resolution topographic data of this fault, the WorldView satellite stereo images were used to generate a 0.5-m-resolution orthophoto and a 1-m-resolution Digital Elevation Model(DEM)of the Litang fault based on the photogrammetry method. With the high-resolution topographic data, the fine geometry of the 1890 earthquake surface rupture zone was mapped in detail. The mapping results show that the total length of the surface rupture is about 27km, with an overall strike of N40°W. The rupture is mainly characterized by sinistral strike-slip motion, with a certain degree of dip-slip component in local areas. Except for the interval of approximately 6km with no surface rupture at the Wuliang River floodplain in the Litang Basin, the surface ruptures are relatively continuous at other locations. In addition, various rupture styles have been identified along the fault, including en echelon tension cracks, mole tracks, sag ponds, fault scarps, and displaced gullies. Furthermore, the sinistral offsets of 90 groups of linear geomorphic markers such as gullies and ridges were measured along the fault, which range from 1m to 82.4m. We further estimated the Cumulative Offset Probability Distribution(COPD)of the offsets located on the terrace I of the Wuliang River, which are all in the range of 0-9m. The COPD plot displays four distinct peaks at 1.3m, 2.4m, 4.3m, and6.1m, respectively. Previous studies have reported that the terrace I of Wuliang River formed at about(4 620±40)a BP. Thus, it can be indicated that the Litang fault may have experienced at least four strong earthquake events since(4 620±40)a BP, and the smallest peak of 1.3m may represent the coseismic displacement of the most recent 1890 earthquake. The rupture length of the latest 1890 earthquake was about 27km, and the coseismic sinistral offset was about 1.3m, yielding an estimated moment magnitude of M_W6.8-7.1. The coseismic offset of the other three earthquakes was about 1.8m, 1.9m, and 1.1m from old to new, respectively, yielding a magnitude estimate of M_W7.3, M_W7.3, and M_W7.0, with a size comparable to the 1890 earthquake. The research results fully demonstrate the potential of high-resolution remote sensing images in the study of fine characteristics of earthquake surface rupture.

Slip rate is one of the most important parameters in quantitative research of active faults. It is an average rate of fault dislocation during a particular period, which can reflect the strain energy accumulation rate of a fault. Thus it is often directly used in the evaluation of seismic hazard. Tectonic activities significantly influence regional geomorphic characteristics. Therefore, river evolution characteristics can be used to study tectonic activities characteristics, which is a relatively reliable method to determine slip rate of fault. Based on the study of the river geomorphology evolution process model and considering the influence of topographic and geomorphic factors, this paper established the river terrace dislocation model and put forward that the accurate measurement of the displacement caused by the fault should focus on the erosion of the terrace caused by river migration under the influence of topography. Through the analysis of the different cases in detail, it was found that the evolution of rivers is often affected by the topography, and rivers tend to migrate to the lower side of the terrain and erode the terraces on this side. However, terraces on the higher side of the terrain can usually be preserved, and the displacement caused by faulting can be accumulated relatively completely. Though it is reliable to calculate the slip rate of faults through the terrace dislocation on this side, a detailed analysis should be carried out in the field in order to select the appropriate terraces to measure the displacement under the comprehensive effects of topography, landform and other factors, if the terraces on both sides of the river are preserved. In order to obtain the results more objectively, we used Monte Carlo method to estimate the fault displacement and displacement error range. We used the linear equation to fit the position of terrace scarps and faults, and then calculate the terrace displacement. After 100, 000 times of simulation, the fault displacement and its error range could be obtained with 95%confidence interval. We selected the Gaoyan River in the eastern Altyn Tagh Fault as the research object, and used the unmanned air vehicle aerial photography technology to obtain the high-resolution DEM of this area. Based on the terrace evolution model proposed in this paper, we analyzed the terrace evolution with the detailed interpretation of the topography and landform of the DEM, and inferred that the right bank of the river was higher than the left bank, which led to the continuous erosion of the river to the left bank, while the terraces on the right bank were preserved. In addition, four stages of fault displacements and their error ranges were obtained by Monte Carlo method. By integrating the dating results of previous researches in this area, we got the fault slip rate of(1.80±0.51)mm/a. After comparing this result with the slip rates of each section of Altyn Tagh Fault studied by predecessors, it was found that the slip rate obtained in this paper is in line with the variation trend of the slip rate summarized by predecessors, namely, the slip rate gradually decreases from west to east, from 10~12mm/a in the middle section to about 2mm/a at the end.

With the development of photogrammetry technology and the popularity of unmanned aerial vehicles (UAVs)technology in recent years, using UAV photogrammetry technology to rapidly acquire high precision and high resolution topographic and geomorphic data on the fault zone has gradually become an important technical means. This paper first summarizes the basic principle and workflow of a new digital photogrammetry technology, SfM (Structure from Motion), which is simple, efficient and low cost. Using this technology, we conducted aerial image acquisition and data processing for a typical fault landform on the northern of Caka Basin in Qinghai. The digital elevation model (DEM)with 6.1cm/pix resolution is generated and the density of point cloud is as high as 273 points/m². The coverage area is 0.463km². Further, the terrain and slope data parallel to the fault direction are extracted by topographic analysis method, and combined with the contour map and the slope diagram generated by the DEM, a fine interpretation and quantitative study of complex multilevel geomorphic surfaces is carried out. Finally, based on the results of sophisticated interpretation of geomorphology, we got the vertical displacements of the T₁ terrace to the T₃ terrace as (1.01±0.06)m, (1.37±0.13)m and (3.10±0.11)m, and the minimum vertical displacements of the T₄ terrace and the T₅ terrace as (3.77±0.14)m and (5.46±0.26)m, respectively, through the topographic profile data extracted by DEM. Such vertical displacement parameters are difficult to obtain directly by traditional remote sensing images, which shows the great application prospect of UAV photogrammetry technology in the quantitative study of active tectonics.

Qilian Shan and Hexi Corridor, located in the north of Tibetan plateau, are the margin of Tibetan plateau's tectonic deformation and pushing. Its internal deformations and activities can greatly conserve the extension process and characteristics of the Plateau. The research of Qilian Shan and Hexi Corridor consequentially plays a significant role in understanding tectonic deformation mechanism of Tibetan plateau. The northern Yumushan Fault, located in the middle of the northern Qilian Shan thrust belt, is a significant component of Qilian Shan thrust belt which divides Yumushan and intramontane basins in Hexi Corridor. Carrying out the research of Yumushan Fault will help explain the kinematics characteristics of the northern Yumushan active fault and its response to the northeastward growth of the Tibetan plateau.Because of limited technology conditions of the time, different research emphases and some other reasons, previous research results differ dramatically. This paper summarizes the last 20 years researches from the perspectives of fault slip rates, paleao-earthquake characteristics and tectonic deformation. Using aerial-photo morphological analysis, field investigation, optical simulated luminescence(OSL)dating of alluvial surfaces and topographic profiles, we calculate the vertical slip rate and strike-slip rate at the typical site in the northern Yumushan Fault, which is(0.55±0.15)mm/a and(0.95±0.11), respectively. On the controversial problems, namely "the Luotuo(Camel)city scarp" and the 180 A.D. Biaoshi earthquake, we use aerial-photo analysis, particular field investigation and typical profile dating. We concluded that "Luotuo city scarp" is the ruin of ancient diversion works rather than the fault scarp of the 180 A.D. Biaoshi earthquake. Combining the topographic profiles of the mountain range with fault characteristics, we believe Yumu Shan is a part of Qilian Shan. The uplift of Yumu Shan is the result of Qilian Shan and Yumu Shan itself pushing northwards. Topographic profile along the crest of the Yumu Shan illustrates the decrease from its center to the tips, which is similar to the vertical slip rates and the height of fault scarp. These show that Yumu Shan is controlled by fault extension and grows laterally and vertically. At present, fault activities are still concentrated near the north foot of Yumu Shan, and the mountain ranges continue to rise since late Cenozoic.

High-precision and high-resolution topographic data are the basis of quantitative study of active tectonics. The appearance and rapid development of photogrammetry method provide an economical and effective technical means for obtaining high precision terrain data. Compared with traditional measurement methods, the photogrammetry method can be carried out in a wide range without being limited by the ground visibility conditions, and the measurement cost is also relatively low. Especially in recent years, with the rapid development of computer vision theory and efficient automatic feature matching algorithm, a 3D reconstruction technique called "Structure from Motion"(SfM)was introduced into the photogrammetry method, greatly improving the automation of the photogrammetry method. This paper mainly introduces the basic principle and the development of photogrammetry method, and also summarizes the application of photogrammetry method in the study of active tectonics, and finally demonstrates the great application potential of photogrammetry method in the quantitative study of active tectonics by displaying a specific application example.