Bayan Hara Block is one of the most representative active blocks resulting from the lateral extrusion of Tibet Plateau since the Cenozoic. Its southern and northern boundary faults are characterized by typical strike-slip shear deformation. Its eastern boundary is blocked by the Yangze block and its horizontal movement is transformed into the vertical movement of the Longmen Shan tectonic belt, leading to the uplift of the Longmen Shan Mountains and forming a grand geomorphic barrier on the eastern margin of the Tibet Plateau. A series of large earthquakes occurred along the boundary faults of the Bayan Hara Block in the past twenty years, which have attracted attention of many scholars. At present, the related studies of active tectonics on Bayan Hara Block are mainly concentrated on the boundary faults, such as Yushu-Ganzi-Xianshuihe Fault, East Kunlun Fault and Longmen Shan Fault. However, there are also some large faults inside the block, which not only have late Quaternary activity, but also have tectonic conditions to produce strong earthquake. These faults divide the Bayan Hara Block into some secondary blocks, and may play important roles in the kinematics and dynamics mechanism of the Bayan Hara Block, or even the eastern margin of the Tibet Plateau. The Dari Fault is one of the left-lateral strike-slip faults in the Bayan Hara Block. The Dari Fault starts at the eastern pass of the Kunlun Mountains, extends eastward through the south of Yalazela, Yeniugou and Keshoutan, the fault strike turns to NNE direction at Angcanggou, then turns to NE direction again at Moba town, Qinghai Province, and the fault ends near Nanmuda town, Sichuan Province, with a total length of more than 500km. The fault has been considered to be a late Quaternary active fault and the 1947 M73/4 Dari earthquake was produced by its middle segment. But studies on the late Quaternary activity of the Dari Fault are still weak. The previous research mainly focused on the investigation of the surface rupture and damages of the 1947 M73/4 Dari earthquake. However, there were different opinions about the scale of the M73/4 earthquake surface rupture zone. Dai Hua-guang(1983)thought that the surface rupture of the earthquake was about 150km long, but Qinghai Earthquake Agency(1984)believed that the length of surface rupture zone was only 58km. Based on interpretation of high-resolution images and field investigations, in this paper, we studied the late Quaternary activity of the Dari Fault and the surface rupture zone of the 1947 Dari earthquake. Late Quaternary activity in the central segment of the Dari Fault is particularly significant. A series of linear tectonic landforms, such as fault trough valley, fault scarps, fault springs and gully offsets, etc. are developed along the Dari Fault. And the surface rupture zone of the 1947 Dari earthquake is still relatively well preserved. We conducted a follow-up field investigation for the surface rupture zone of the 1947 Dari earthquake and found that the surface rupture related to the Dari earthquake starts at Longgen village in Moba town, and ends near the northwest of the Yilonggounao in Jianshe town, with a length of about 70km. The surface rupture is primarily characterized by scarps, compressional ridges, pull-apart basins, landslides, cleavage, and the coseismic offset is about 2~4m determined by a series of offset gullies. The surface rupture zone extends to the northwest of Yilonggounao and becomes ambiguous. It is mainly characterized by a series of linear fault springs along the surface rupture zone. Therefore, we suggest that the surface rupture zone of the 1947 Dari earthquake ends at the northwest of Yilonggounao. In summary, the central segment of the Dari Fault can be characterized by strong late Quaternary activity, and the surface rupture zone of the 1947 Dari earthquake is about 70km long.

Small earthquakes have been recorded in Yibin area, Sichuan Province since 1970, the frequency and intensity of seismicity have shown an increasing trend in recent ten years, and the earthquakes are distributed mainly in Changning, Gongxian and Junlian areas. Based on the seismic data from January 2008 to May 2015 recorded by Sichuan and Yunnan regional networks and Yibin local network, seismicity analysis, precise location and velocity structure inversion for earthquakes in Yibin area are carried out, the three-dimensional spatial distribution of seismic activity and the velocity structure at different depths in this region are investigated, trying to analyze the seismic activity law and seismogenic mechanism in Yibin area.
The earthquake relocation result shows that the spatial cluster distribution of earthquakes is more obvious in Yinbin area, the earthquakes are concentrated in Changning-Gongxian and Gongxian-Junlian regions. The seismic activity presents two dominant directions of NW and NE in Changning-Gongxian region, and shows asymmetric conjugate distribution, the long axes of NW-trending and NE-trending seismic concentration area are about 30km and 12km respectively, and the short axes are about 5km. There is a seismic sparse segment near Gongxian, the frequency and intensity of seismicity in the southeast side are obviously higher than that in the northwest side, and the earthquakes with larger magnitude are relatively deep, the focal depth is gradually shallower with the distance away from Gongxian. Seismic activity is sparse in the west and dense in the east in Gongxian-Junlian region, the predominant direction of earthquakes in the seismic dense area of the eastern segment is NE. Seismic activity extends in opposite direction in the easternmost part of the two earthquake concentrated area.
The P-wave velocity structure at different depths in the study area is obtained using joint inversion method of source and velocity structure. In view of the predominant focal depth in this region, this paper mainly analyzes the velocity structure of the upper crust within 10km. Within this study area, the P-wave velocity of earthquake concentration areas is relatively high within 10km of the predominant focal depth, especially in the northwest of Gongxian and eastern Junlian area, the P-wave velocity on the southeast of Gongxian increases gradually with depth, especially at 6km depth. These high-velocity zones are generally related to brittle and hard rocks, where the stress is often concentrated.
Comparing earthquake distribution and velocity structure, seismic activity in this area mainly occurs in high-low velocity transition areas, the inhomogeneity of velocity structure may be one of the factors controlling earthquake distribution. The transition zone of high and low velocity anomalies is not only the place where stress concentrates, but also the place where the medium is relatively fragile, such environment has the medium condition of accumulating a large amount of strain energy and is prone to fracture and release stress.

On 23 September 2016, two earthquakes with magnitude of M4.9 and M5.1 occurred successively near Litang city in Sichuan Province, southwestern China. These two events are located between two large-scale fault zones, i.e., the Jinshajiang and Litang faults, in the northwest of the Sichuan-Yuannan active block, eastern Tibetan plateau. Based on the phase data and waveform data from the Sichuan regional seismic network, the M4.9 and M5.0 mainshocks and 390 aftershocks have been relocated using the multi-step locating method, and the focal mechanism solutions and centroid depths for the two mainshocks were calculated by the CAP waveform inversion method. From the spatial distribution of the relocated aftershocks and fault plane solutions of the two mainshocks, combining with the seismic intensity map and tectonic setting, we suggested that the two earthquakes were generated by the E-W trending northward dipping Hagala fault. The nodal plane consistent with the strike and dip of the Hagala fault is interpreted as the coseismic rupture plane with a dip angle of 44° for both the M4.9 and M5.1 earthquakes. And we inferred that the M4.9 and M5.1 earthquakes may be resulted from the nearly E-W striking Hagala normal faulting in the upper crust between the Litang and Batang regions due to the continuous eastward extrusion of the material of the Qiangtang block in the west.

The Oct.1,2014 M5.0 Yuexi earthquake occurred on the Daliang Shan fault zone where only several historical moderate earthquakes were recorded.Based on the waveform data from Sichuan regional seismic network,we calculated the focal mechanism solution and centroid depth of the M5.0 Yuexi earthquake by CAP (Cut and Paste) waveform inversion method,and preliminarily analyzed the seismogenic structure.We also calculated the apparent stress values of the M5.0 earthquake and other 14 M_L≥4.0 events along the Shimian-Qiaojia fault segment of the eastern boundary of the Sichuan-Yunnan block.The result indicates that the parameters of the focal mechanism solution are with a strike of 256°,dip of 62°,and slip of 167° for the nodal plane Ⅰ,and strike of 352°,dip of 79°,and slip of 29° for the nodal plane Ⅱ.The azimuth of the P axis is 121° with dip angle of 11°,the azimuth of T axis is 217° with dip angle of 28°,and the centroid depth is about 11km,and moment magnitude is M_W5.1.According to the focal mechanism solution and the fault geometry near the epicenter,we infer that the seismogenic fault is a branch fault,i.e.,the Puxiong Fault,along the central segment of the Daliang Shan fault zone.Thus,the nodal plane Ⅱ was interpreted as the coseismic rupture plane.The M5.0 Yuexi earthquake is a strike-slip faulting event with an oblique component.The above findings reveal the M5.0 Yuexi earthquake resulted from the left-lateral strike-slip faulting of the NNW Dalang Shan fault zone under the nearly horizontal principal compressive stress regime in an NWW-SEE direction.The apparent stress value of the Yuexi earthquake is 0.99MPa,higher than those of the M_L ≥ 4.0 earthquakes along the eastern boundary of the Sichuan-Yunnan block since 2008 Wenchuan M8.0 earthquake,implying a relatively high stress level on the seismogenic area and greater potential for the moderate and strong earthquake occurrence.It may also reflect the current increasing stress level of the entire area along the eastern boundary,and therefore,posing the risk of strong earthquakes there.