关键词: 高压电容器, 充放电, 电爆炸, 动态监测, 触发地震

Abstract: An external small disturbance may trigger seismic events when the fault is in a critical state. The problems related with earthquakes triggered by the dynamic stress such as blasting loads, impact loads, volcanic eruptions and strong earthquakes, have usually drawn wide concerns in earthquake science, and the corresponding research contents are quite extensive, including earthquake triggering mechanisms, triggering earthquake uncertainty, aftershock triggering, and so on. Among them, experimental research is an important way to understand the stress triggering conditions and physical mechanisms, such as the influence of load disturbance on fault friction traits, the influence of periodic disturbance of tidal stress on fault instability, etc., all of which can be gained through experimental investigations. Among them, "how to trigger" is a basic scientific problem to increase the understanding of earthquake prediction theory, thus receiving more attention. There are also some studies that focus on "what happened after the trigger", that is, the sliding instability generated by the triggering method, and then the evolution characteristics of the sliding instability process. The well-known experimental study of the super-shear rupture process is conducted by using the electric explosion method to trigger the fault instability, and the high-speed camera records the super-shear rupture during the fault instability. This means that when the trigger source is controllable, it is possible to generate different types of instability processes, and then to explore which earthquakes will be triggered at different time and space positions under different stress states by means of active triggering. The study of stability analysis and instability process has important scientific significance.A stable system of capacitive high-voltage pulse discharge and recharge is one of basic techniques for studying the triggered earthquakes in laboratory. Based on the wire electric explosion method, this paper develops a controllable trigger experiment system. By designing a new capacitive high-voltage pulse charge and discharge system, while considering the actual needs of monitoring and system timing, multiple functions are integrated into one system. Functionally, in addition to realizing the dynamic loading and unloading function of the wire electric explosion method, the discharge process can be monitored, and the triggering, synchronization and timing signal output is performed with other observation systems, thus realizing the whole process monitoring of the dynamic disturbance action. After testing, the following functions are achieved:1)The voltage and current of the high-voltage charging power supply system can be automatically adjusted, and the system can be shut off after charging; 2)Control modes include manual and remote controls. These two modes can control the recharge, release and pulse discharge of the high voltage capacitor; 3)The system can produce multi-channel synchronous output, which satisfy multiple systems working together. In particular, the remote sensing method greatly improves the experimental maneuverability and security; 4)The system has multiple sets of gas discharge tube to trigger discharge, with a wide range of discharge voltage of 500~5 000V; 5)Roche coil resistance integral current detection can meet the transient resistance, large current detection. Test results indicate that this system has good repeatability and stability with the same discharge energy and discharge energy regulator, which is conducive to carry out single channel trigger of high-pressure discharge experiment. In short, the new charging and discharging system can meet the requirements of experimental study of triggering earthquake. In addition, this system can be used to generate the stress disturbance under certain static and dynamic conditions, and then judge whether this kind of mechanical conditions in active fault systems is currently stable.In short, a controllable single-shot discharge system is developed by a capacitive high-voltage pulse discharge system, which provides a good technical basis for experimental research on triggering earthquakes. In addition, the new system also has application significance:1)multiple triggering output can simultaneously start multiple systems and improve the efficiency of observation. Fault instability is a characteristic of transient response, so, its observation requires high-speed acquisition equipment, which is difficult to control on observation; the trigger system is controllable, with active synchronization observation using physical parameters; 2)stress disturbance can be triggered under static and dynamic loads to detect the safety and stability of the fault system with active trigger.

Key words: high-voltage condense, recharge-discharge, wire exploding, dynamic monitoring, earthquake triggering