SEISMOLOGY AND GEOLOGY ›› 2009, Vol. 31 ›› Issue (3): 544-550.DOI: 10.3969/j.issn.0253-4967.2009.03.015

• Brief Report • Previous Articles     Next Articles

A SIMPLE APPROACH FOR PREHEAT TEMPERATURE DETERMINATION IN FINE-GRAINED QUARTZ OPTICALLY STIMULATED LUMINESCENCE DATING

KANG Shu-gang1,3, LU Yan-chou1,2, WANG Xu-long1, DU Jin-hua1,3   

  1. 1. State Key Laboratory of Loess and Quaternary Geology, Institute of Earth Environment, CAS, Xi'An 710075, China;
    2. State Key Laboratory of Earthquake Dynamics, Institute of Geology, China Earthquake Administration, Beijing 100029, China;
    3. Graduate University of Chinese Academy of Sciences, Beijing 100049, China
  • Received:2009-04-28 Revised:2009-07-17 Online:2009-09-09 Published:2009-12-11

黄土细颗粒石英光释光测年中预热温度选取的简易方法

康树刚1,3, 卢演俦1,2, 王旭龙1, 杜金花1,3   

  1. 1. 中国科学院地球环境研究所, 黄土与第四纪地质国家重点实验室, 西安, 710075;
    2. 中国地震局地质研究所, 地震动力学国家重点实验室, 北京, 100029;
    3. 中国科学院研究生院, 北京, 100049
  • 作者简介:康树刚,男,1982年出生,2004年毕业于吉林大学,现为中国科学院地球环境研究所博士研究生,第四纪地质学专业,电话:029-88323864,E-mail:kshg@ieecas.cn.
  • 基金资助:
    中国科学院黄土与第四纪地质国家重点实验室开放基金(SKLLQG0717);自主部署课题(ZYSQ0807)资助

Abstract: Equivalent dose(De)preheat plateau test is an often used approach to determine an appropriate preheat temperature in optically stimulated luminescence(OSL)dating. The preheat temperature chosen in OSL dating should be in the plateau region. When the preheat time is fixed as 10s,the De preheat plateau regions are 250~280℃ and 180~260℃ for regeneration dose and test dose respectively for fine-grained quartz in Chinese loess,no matter using single-aliquot regenerative-dose(SAR)protocol or sensitivity change corrected multiple-aliquot regenerative-dose(SMAR)protocol. After reanalyzing the De preheat plateau data derived by SMAR protocol,variation of the ratio of natural OSL intensity to regenerated dose aliquot OSL intensity(N/R)with preheat temperature changes in the similar way with the plot of De as a function of preheat temperature. We suggest that plot of N/R as a function of preheat temperature can be the substitute of De preheat plateau test. This gives us a simple and time-saving approach to determine the preheat temperature in fine-grained quartz OSL dating.

Key words: fine-grained quartz, SAR, SMAR, preheat plateau

摘要: 等效剂量预热温度坪实验是光释光(OSL)测年中确定预热温度的常用手段,一般选择坪区温度作为OSL测年的预热温度。对于黄土细颗粒石英,无论采用单片再生法(SAR)还是简单多片再生法(SMAR),以10s为预热时间,其天然和再生剂量预热温度坪区间均为250~280℃,试验剂量的预热温度分布较广,如180~260℃。常规等效剂量预热温度坪实验需要耗费较长的实验室时间。通过对SMAR法测试数据的再分析发现,天然与再生剂量OSL信号校正强度的比值(N/R)随预热温度的变化与常规等效剂量坪实验中等效剂量随预热温度的变化有着相似的趋势,这样,N/R预热温度坪就可作为黄土样品细颗粒石英等效剂量预热温度坪的替代,为实验室OSL测年确定预热温度提供一个简捷途径。

关键词: 细颗粒石英, 单片法, 简单多片法, 预热温度坪

CLC Number: